Standard Epoxies

Infusion Epoxies

PRO-SET® Infusion epoxies result in lightweight, high performance composites that will withstand long-term cyclic loading in the harshest environments.

PRO-SET Infusion epoxies are super-low viscosity systems with a range of hardeners to meet the demands of modern infusion processes. They develop excellent physical properties at room temperature and may be post-cured to further enhance performance.

A complete range of hardeners to complement the infusion resin

PRO-SET Infusion Epoxies
Resins
Infusion Resin INF-114
Hardeners
Fast Infusion Hardener INF-210
Medium Infusion Hardener INF-211
Slow Infusion Hardener INF-212
Extra Slow Infusion Hardener INF-213

Hardeners may be blended for targeted cure time

Match the correct resin to your exact requirements

This guide compares the typical physical properties. These test specimens are cured at room temperature to gelation and at 82°C for eight hours, unless otherwise noted. Neat epoxy samples are used for testing.  These are typical values, not to be construed as specifications.

Property Standard units INF-114
Resin¹
Mix Ratio by Volume R:H 3:1
Mix Ratio by Weight R:H 3.65:1
Mixed Viscosity @25℃ ASTM D2196 mPas -245
Mixed Viscosity @22℃ gcm-3 -1.14
Compression Yield ASTM D695 MPa -97
Tensile Strength ASTM D638 MPa -71.3
Tensile Modulus ASTM D638 GPa -3.38
Tensile Elongation ASTM D638 % -4.95
Flexural Strength ASTM D790 MPa -123.7
Flexural Modulus ASTM D790 GPa -3.19
Tg Ultimate via DMA² ASTM E1640³ >85.2

As of press time, TBD values are undergoing testing.
¹Average of properties for combinations with INF-210, INF-211, INF-212 and INF-213 Hardeners.
2Additional post cure may be required; contact us for details.
31 HZ, 3°C per minute

Match the correct hardener to your exact requirements

Property Standard INF-210
Hardener
INF-211
Hardener
INF-212
Hardener
INF-213
Hardener
150g Pot Life @ 25℃ ASTM D2471 27min 122 min 185 min 262 min
500g Pot Life @ 25℃ ASTM D2471 25 min 85 min 132 min 175 min
Approx. working time @ 25℃ 75-90 min 3-4 hr 6-7 hr 10 hr

Downloadable technical datasheets

PRO-SET INF-114 with INF-210 Fast Cure Infusion Epoxy
PRO-SET INF-114 with INF-211 Medium Cure Infusion Epoxy
PRO-SET INF-114 with INF-212 Slow Cure Infusion Epoxy
PRO-SET INF-114 with INF-213 Extra Slow Cure Infusion Epoxy
PRO-SET INF-114 with INF-249-HT Medium Cure High Tg Infusion Epoxy TDS

DNV GL Approval. PRO-SET INF-114 resin with INF-210, INF-211, INF-212 and INF-213 hardeners combinations have all been awarded Type Approval by DNV GL.